Description

This auction is just for the two 3d printed parts, that I designed and printed to help the press run smoother. The pictures show my own press for reference, but no hornady parts are included in the auction, just the two printed parts in the last picture. The pusher was designed to prevent cases from tipping as they are pushed from the case feeder into the shellplate. It also provides much better contact with the case and more positive engagement as the case slides over the retaining spring. The alignment wedge adds a bit more clearance for the dropped case to fall into place. It ensures that the slider is consistently in an outward position when the brass drops. This case pusher and aligment wedge were designed by me from the ground up to allow smoother feeding and operation. They've been thoroughly tested for well over 10,000 rounds and has held up with little to no signs of wear or decrease in function. Color of item may vary from the pictures. For now, I am using gray. Custom colors not available at this time. features: 9mm brass shaped curved area for better contact with the case extended bottom tab to press from closer to the bottom of the case (important to reduce tipping) slightly longer profile to apply more pressure into the shellplate tapered bottom to conform to shell plate tapered top to conform to case dropper assembly wedge moves the pusher back slightly more so that there's plenty of room for the case to drop Please note that there may be other factors influencing the function of your press. This item is only designed to rule out the issues caused by an imperfectly fitting v block. If you press has other issues this item may not correct them. Some minor sanding or filing may be needed to fit these pieces to your press, due to manufacturing tolerances. One wedge and one pusher are included. You reuse your press' original mounting screw for the pusher. The wedge is press-fit. At this time no other calibers are being offered. Any questions, please let me know.